Timing belt malfunctions can occur at any time. If likelihood happens and your belt decides to conk out while you’re driving you may be put right into a harmful state of affairs. Thankfully, correct timing belt upkeep and substitute when obligatory will tremendously cut back the possibilities of a timing belt-associated accident in your 2004 Toyota Tacoma 2.7 liter.
Toyota Tacoma Replace the Timing Belt Instructions
Flip the engine off. Discover the hood opening swap, which is to the backside proper of the steering wheel and marked with a black and white image of a hood opening. Pull again the swap and make your strategy to the front of the automobile. Pull up and prop open the hood tightly. Remove the negative cable related to your automobile battery. Just remember to have your radio PIN code as a result of remove the battery connector will reset your radio console, and as a way to use your radio, you will have the PIN.
Find the distributor cap; you may establish this cover by the letters TDC printed on the high. Usually, the cap shall be on certainly one of the first three pistons on the left aspect of the engine. Use your adjustable socket or wrench to open up the TDC cap slowly till it aligns with the “1″ place on the exterior portion of the TDC cap.
Test that the distributor rotor is lined up with the “1″ line on the distributor housing, which tells you the rotor is near being in the correct place to make use of the first by third cylinders. Rotate the pistons one other couple of occasions to ensure every part is operating accurately.
Remove the plastic and rubber housing that forestalls entry to the timing belt equipment slowly by pulling every particular person rubber molding piece out one after the other. Place the housing apart, you have to to exchange it later.
Remove the timing belt from beneath the housing and place apart. Pull your substitute timing belt over the rollers and ensure they’re on securely and hooked up very effectively. Replace the plastic rubber housing and shut the hood. Flip your car on and off 3 times over an hour interval and depart it on to ensure the belt is working accurately.
[source ehow.com]