Ready for the timing belt of your automobile to fail earlier than altering leads to excessive price repairs, since there’ll usually be harm to another elements of the engine to. If the timing belt in a Daewoo Leganza stretches and breaks, the valves within the engine will hit the pistons and trigger intensive engine injury. Producers of the Daewoo Leganza advocate that the timing belt be modified after each seventy two 000 miles.
Daewoo Leganza Timing Belt Change Instructions
Disconnect the negative battery cable and lay it apart. Make sure that the cable will not be in touch with any metallic a part of the automobile. Remove the consumption air sensor from the consumption air duct and the consumption air tube from the throttle physique. Utilizing a Philips screw driver take away the screws of the air filter housing and take away the housing.
Increase the car utilizing the hydraulic elevate and jack stands. Use a lug wrench to take away the front wheels and the front fender interior splashguard. Utilizing a wrench, relieve the stress on the accent belt tensioner. Slide the accent drive belt off the crankshaft pulleys. Choose the suitable sized sockets out of your set and take away the crankshaft pulley bolts. Remove the crankshaft pulleys.
Place the ground jack beneath the oil pan and slide the wood board onto the jack. Jack up the board till it touches the oil pan in order that the jack lifts up the engine. Utilizing the suitable socket take away the engine mount bracket and energy steering hose bracket.
Flip the crankshaft clockwise utilizing a socket hooked up to the middle bolt of the crankshaft in order that the timing marks on the crankshaft sprocket align the notch on the rear timing belt cowl. The crankshaft sprocket timing marks also needs to align with the notches on the valve cowl.
Use a wrench to loosen the bolt on the timing belt tensioner. Flip the tensioner clockwise and tighten the tensioner bolt. Slide the timing belt out. Slide the brand new timing belt in over the crankshaft pulleys. Loosen the tensioner bolt and switch the tensioner anti-clockwise utilizing a wrench. When the tensioner pointer is aligned with the notch on the block tighten the tensioner bolt.
Utilizing a sprocket flip the crankshaft twice in an anti-clockwise course till the timing marks align as completed in step four. Reassemble the engine elements and lower the car.
[taken from ehow.com]